You can’t just use any old cleaner. It needs to be something that won’t damage the surface of your panels and will remove dirt, grime, bird droppings, algae, and other contaminants without harming them.

The solar panel is an essential part of solar light, but it’s also the hardest to clean. Dirt and dust can build up on the surface over time, reducing efficiency and shortening battery life. It’s not easy to reach those hard-to-clean areas with your hand or a rag, so we recommend using an old toothbrush instead!

You’ll want to start by removing any debris from the surface of the panel with a soft brush or cloth. Once that’s done, use water and soap (or an eco-friendly cleaner) to remove dirt and grime from all panel surfaces. Rinse off with fresh water before letting the panel air dry completely. That’s it! Your solar panels will be as good as new in no time. Repeat this process every 2-3 months to keep the panels in their best condition.

If you think your solar panels are cloudy and aren’t catching the light properly then you can fix this by covering the plastic part with tape and clean the solar panel with soap water. This is done in order to remove any debris which is stuck on the panel. Once done, wipe it down with a clean, wet rag to remove any suds. Once you have made sure that there isn’t any debris, spray a layer of lacquer onto the panel to remove fading. Let it dry for 30 minutes and remove the tape from the sides of the panel.

If you see corrosion in the battery compartment, then you should remove the batteries. Put a drop or two of vinegar as it helps neutralize and dissolve the corrosion. Apply it to any corroded areas on the battery and terminals. Let the vinegar sit for a minute to soak in, once soaked scrub the corroded areas with a hard bristle brush to clean the terminals. If the corrosion does not come off then you could use fine-grit sandpaper. Put the batteries back in and check the light, if the batteries are dead then you might replace them with a fresh pair.

To know more, visit us at www.gobluesun.com.

FAQs

How Effective Are Solar Panels?

Most figures say that solar panels can be effective anywhere between 15% and 18%, meaning they convert only between 15% and 18% of sunlight into electricity while absorbing the rest like it would be anything else. That being said, there is a huge variety of factors that change your specific efficiency for a particular system

How Are Solar Panels Installed?

The installation process of solar panels is possible on roofs or the ground. Most homes have natural sunlight available for maximum energy production, so that’s where most people install their systems. But if a roof doesn’t meet your specifications and you still want to tap into this renewable resource, it might be better off installing outside in direct sunlight instead

LEAVE A REPLY

Please enter your comment!
Please enter your name here